Sheared or slit edges on coated steel sheet expose bare substrate. Pure zinc (galvanized) coatings and aluminum-zinc alloy coatings (Galvalume or AZ) both respond to this exposure, yet their long-term edge behavior diverges under outdoor atmospheric conditions. Aluminum-zinc systems combine a durable barrier contribution from aluminum with a milder sacrificial contribution from zinc, producing measurable differences in edge creep resistance.
Aluminum Barrier Action and Limited Edge Protection
Coatings conforming to ASTM A792 typically contain about 55 % aluminum, 43.4 % zinc and 1.6 % silicon. Solidification creates aluminum-rich dendrites that enclose zinc-rich interdendritic regions. The aluminum-rich phase forms a stable oxide that functions primarily as a barrier, slowing general surface corrosion. At a cut edge the zinc-rich regions dissolve preferentially, delivering cathodic protection to the exposed steel. Moisture-driven corrosion products accumulate in the interdendritic network and at the cut face, reducing the rate at which remaining coating is consumed. BlueScope Steel Technical Bulletin TB-10 (Rev. 5, November 2003) describes this automatic build-up of zinc compounds as the "self-healing" property of zinc-containing metallic coatings.

Because aluminum occupies most of the coating volume, free zinc available for rapid galvanic action is limited. The sacrificial effect is less aggressive than that of pure zinc, yet the coating mass persists longer.
Pure Zinc Sacrificial Behavior at Cut Edges
Pure-zinc coatings depend almost entirely on sacrificial anode action once the continuous barrier is interrupted by shearing or piercing. Zinc's higher activity can protect a somewhat larger distance under persistently wet conditions, but the same activity leads to faster coating consumption. Atmospheric exposure data indicate that an AZ150 coating (minimum 150 g/m² total both sides) outlasts a Z275 pure-zinc coating in overall service life for roofing and cladding, even though absolute zinc content is lower.
BlueScope's channel-exposure method illustrates the point. Channels from 0.4 mm to 4.0 mm wide were cut through both coating types and exposed for 12 months at Port Kembla, New South Wales, in an aggressive industrial/coastal atmosphere. Narrow channels corresponding to typical roofing and cladding gauges showed little base-steel corrosion for either coating. TB-10 therefore notes that cut-edge performance of unpainted ZINCALUME in the thin thickness range used for these products is similar to zinc-coated sheet, while overall corrosion performance favors the aluminum-zinc product.
When the Edge Advantage Is Stronger or Weaker
The relative benefit of the aluminum-zinc combination appears most clearly in outdoor building service with intermittent wetting and drying-conditions common in rural, suburban and moderate industrial atmospheres across temperate and subtropical regions. Under these cycles the aluminum barrier preserves coating mass and corrosion products help seal the edge. The advantage diminishes under continuous immersion or high-chloride splash that demands stronger sacrificial action, on heavier gauges where coating-to-edge-area ratio is smaller, or when edges remain contaminated by swarf. Higher coating mass within a given type improves edge protection; application severity should dictate the selected class.

Side-by-Side Comparison
| Coating Type | Cut Protection Characteristics | Outdoor Edge Performance Tendency | Suitable Scenarios |
|---|---|---|---|
| Pure Zinc | Mainly relies on sacrificial protection | Medium | Regular / milder environments |
| Aluminum-Zinc (Galvalume) | Barrier + certain edge protection | Relatively better | Outdoor roofing and wall cladding |
Practical Reference for Forming Operations
Fabricators selecting material for outdoor cut-edge components-roof panels, wall cladding, gutters-can use these documented mechanisms when specifying substrate. Aluminum-zinc coatings to ASTM A792 (or equivalent EN 10346 / AS 1397 AZ classes) supply a practical balance of barrier durability and residual edge protection for most non-severe coastal building applications.
Further product details and supporting technical documentation on Galvalume performance are available through the Galvalume steel coil product range and associated technical resources. Contact us for specifications or samples.